E 21041C | Battery does not charge
Problem Akku wird nicht geladen. Ladeanzeige blinkt bzw. leuchtet rot. Ursache Lösung Lädt der Akku nur ausserhalb des Stromers und...
ERROR AND WARNING MESSAGES 23 Articles
The Stromer error and warning messages are usually cryptic E or W numbers. This topic category attempts to answer what causes them and what solutions exist.
-
-
E 250103 & W 270100 | Sensor voltage close to 0 V
Problem No support. The value „voltage“ displayed in the service menu is outside the sensor's operating range, usually close to 0 V or then... -
E 210005 | Battery can only be charged outside the bike
Problem The battery can only be charged outside the bike. The Stromer offers no support. Cause Solution -
E 210105 | Battery overheated
Problem Recuperation fails in summer temperatures. When switching from recuperation to normal operation, system error E 210105 appears and the... -
NO_BAT - Display V1/V1.1
The "NO_BAT" error on a Stromer S-Pedelec V1 or V1.1 is a generic error message that indicates that the display does not have a... -
NO_COM - Display V1/V1.1
The "NO_COM" error on a Stromer S-Pedelec V1 or V1.1 means that there is no communication between the display and the motor/controller.... -
W 200002 | Battery temperature very low...
Display in the Omi If you press the yellow warning triangle in the Omni display, this warning message appears: If you click on the error number, the... -
W 210100 | Battery voltage increased...
Problem The warning W 210100 appears in the Omni and the text message reads: "Batt. voltage, battery voltage increased. Recovery not possible at this time...